How to Power cycle a Vent

A power cycle on a vent can help to reconnect a vent if it has lost connection with your Ecovent system.

To power cycle a vent, follow these steps below:

  • Remove the middle magnetic faceplate from the vent
  • Remove the battery pack by lightly pressing on the middle tab towards the battery pack
    • The battery pack may begin to lift out after doing so
    • Be careful not to press the reset button next to the serial number sticker
  • Fully remove the battery pack and remove the old batteries
  • Reinsert the battery pack following the arrows on the side of pack
  • Press the battery pack in until the middle tab clicks into place
  • Return the magnetic faceplate to the device
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Article is closed for comments.