To change the batteries in the vent, follow these steps below:
- Remove the middle magnetic faceplate from the vent
- Remove the battery pack by lightly pressing on the middle tab towards the battery pack
- The battery pack may begin to lift out after doing so
- Be careful not to press the reset button next to the serial number sticker
- Fully remove the battery pack and remove the old batteries
- Insert the new batteries, taking care to match up the polarity properly as labeled on one side
- Reinsert the battery pack following the arrows on the side of pack
- Press the battery pack in until the middle tab clicks into place
- Again, be careful not to press the reset button next to the serial number sticker
- If the vent was previously installed, you should see the LED flash once only and no calibration will occur
- If the vent was previously reset (intentionally or accidentally), the vent will calibrate (open and close quickly) and result in a flashing LED
- Return the magnetic faceplate to the device
0 Comments